PHYSIO body sculpting technology is now available For residents in Bonita Springs and the surrounding communities. PHYSIO is a breakthrough in non-surgical body contouring.
If you are unsatisfied with the results you are seeing from your usual exercise routine, PHYSIO may be just the thing you are looking for.
By applying a new concept and approach, PHYSIO can help you to achieve the kind of physique that you likely think is just not possible for you.
PHYSIQ body sculpting technology uses a combination of heat and energy to reduce fat and tone muscle. It targets problem areas for optimal, natural-looking results with NO DOWNTIME.
It is the only device that uses STEP technology (Sequential Thermal & Electrical Pulse) for the body - a combination of electrical muscle stimulation (EMS) and a super luminous diode matrix (SDM).
PHYSIQ delivers EMS and SDM energies from each of its four applicators, offering varied stimulation to maximize patient outcomes in a relaxing, hands-free, procedure. PHYSIQ was designed so that multiple areas, even small body parts, can be targeted. This dual-modality method uses thermal heat to target deep tissue and remove adipose tissue (fat), while electrical pulse stimulation is used to retrain the muscles. The procedure can be obtained at Alivemedispa in Bonita Springs, Florida.
With each of its four applicators capable of delivering two different intensities, PHYSIQ provides the diverse stimulation required to maximize Body Contouring results. With each of the four applicators, this minimally invasive treatment can target two areas at once. There is no downtime between treatments, and they each take less than an hour.
What Will Occur During Treatment
You will have previously discussed with an esthetician the areas you want to concentrate on during your body contouring session at this time. Prior to each session, body hair will be shaved from the treatment areas. After you are at comfortable in the spa bed, the four applicator system of PHYSIQ will be applied to the targeted areas. A single treatment with all four applicators runs for around 30 minutes. Smaller areas may take less time.
All treatments are non-invasive and relatively painless. During the operation, to some, the application locations may feel warm. The PHYSIQ system features a patient control feature, allowing patients to independently alter the setting intensity. You can always adjust controls at any time, to an entensity level that feels right for you. Because treatments may feel a bit uncomfortable when using the higher settings, patients should start at a lower setting and gradually increase intensity over five sessions.
It is recommended to go to treatment for five sessions, with one week in between. However, because every person is different, it is important that you go over your body goals with a body sculpting expert.